Table of Contents
Advertisement
Figure 2: VP-778 Presentation Matrix Switcher/Dual Scaler Rear Panel
#
Feature
17
HDMI IN Connectors
18
DVI-U IN Connectors
19
HDBT IN Connectors
20
AUDIO
HDMI IN 3.5mm Mini Jack
Input
Unbalanced
DVI-U IN 3.5mm Mini Jack
Connectors
HDBT IN 3.5mm Mini Jack
21
MIC 1
6mm Jack
22
COND/DYN MIC Switch
23
MIC 2
6mm Jack
24
COND/DYN MIC Switch
AUDIO LINE OUT (L, R) Terminal Block
25
Connector
26
SPKR OUT 4-pin Terminal Block
27
S/PDIF OUT RCA Connector
28
REMOTE IR 3.5mm Mini Jack (opening)
Covered by a cap. The 3.5mm connector at the end
of the internal IR connection cable fits through this
opening
Connect to the HDMI source (from 1 to 4)
Connect to the video source that can be HDMI, VGA, Component or Composite video (from 1 to 2)
Connect to an HDBT Transmitter (for example, the Kramer TP-580Txr) to pass audio and video
signals as well as serial commands (from 1 to 2)
Connect to an unbalanced audio source for audio takeover of the HDMI 1 to HDMI 4 embedded
audio
Connect to the unbalanced stereo audio of the DVI-U source (from 1 to 2)
Connect to the unbalanced stereo audio source for audio takeover of the HDBT1 to HDBT 2
embedded audio)
Connect to a microphone (see pinout in
Select between a condenser and a dynamic type microphone
Connect to a microphone (see pinout in
Note that Mic2 on the rear panel is identical to Mic2 on the front panel. Mic2 on the front panel
overrides Mic2 on the rear panel when connected
Select between a condenser and a dynamic type microphone
Connect to the L and R balanced stereo audio acceptor
Connects to a pair of loudspeakers
Connect to a digital audio acceptor
Connects to an external IR receiver unit for controlling the machine via an IR remote controller
(instead of using the front panel IR receiver)
Optional. Can be used instead of the front panel (built-in) IR receiver to remotely control the machine
(only if the internal IR connection cable has been installed)
Function
Section 5
.3)
Section 5
.3)
Hide quick links:
Advertisement
Table of Contents
