Table 3: Rear Panel Vp-26 Presentation Matrix Switcher Features - Kramer VP-26 User Manual

Table 3: Rear Panel VP-26 Presentation Matrix Switcher Features

#
1 MIC IN XLR Connector
2 COND. / DYN Selector Switch
3 VGA/UXGA Terminal Block
Connector
4 CV Terminal Block Connector
5 Y/C Terminal Block Connector
6 COMP Terminal Block
Connector
7 VGA/UXGA AUDIO IN Terminal Block
Connectors
8 VGA/UXGA Terminal Block
Connector
9 CV Terminal Block Connector
10 Y/C Terminal Block Connector
11 COMP Terminal Block
Connector
12 CV AUDIO IN Terminal Block Connectors
13 LINE Terminal Block Connector
MASTER
OUTPUT
14 SPKR Terminal Block
Connector
15 Y/C AUDIO IN Terminal Block Connectors
16 RS-232 DB 9F Port
17 RS-485 Terminal Block Port
18 DIP-switches
19 ETH PROG Button
20 ETHERNET Connector
21 ETH Factory Reset Button
1 From 1 to 4
2 Both the LINE and the SPKR terminal block connecters receive the same signal: the LINE outputs it as it is while the SPKR
is amplified
3 Turn the machine OFF using the power switch and then turn it ON while pressing the ETH Factory Reset button. The unit
will power up and load its memory with the factory default definitions
Your Presentation Matrix Switcher
Feature Function
Connect to the microphone
Push in to select a condenser, release to select a
dynamic microphone
Connect to a VGA/UXGA balanced audio acceptor
Connect to a composite video balanced audio
acceptor
Connect to an s-Video balanced audio acceptor
Connect to a component video balanced audio
acceptor
Connect to the VGA/UXGA balanced audio sources
Connect to a VGA/UXGA balanced audio acceptor
Connect to a composite video balanced audio
acceptor
Connect to an s-Video balanced audio acceptor
Connect to a component video balanced audio
acceptor
Connect to the composite video balanced audio
1
sources
Connect the master balanced audio channel
2
acceptor
Connect to a pair of loudspeakers
Connect to the s-Video balanced audio sources
Connects to the PC or the Remote Controller
Pins B (-) and A (+) are for RS-485; Pin G may be
connected to the shield (if required)
DIP-switches for setup of the unit (DIPs 1, 2 and 3
are for setting the machine # and DIP 4 is for RS-485
termination; see section 6.8)
Press to upgrade the Ethernet microcontroller
firmware (see section 8.2)
Connects to the PC or other Serial Controller through
computer networking
Press to reset to factory default definitions
IP Address: 192.168.1.39
Mask: 255.255.255.0
Gateway: 192.168.1.1
1
1
3
:
9