Propane Heaters; Burner Installation, Norseman 200 Plus And Norseman 250 - L.B. White 320 Owner's Manual And Instructions

12
Vertical Convection Heaters
Burner Installation
Norseman 200 Plus and Norseman 250
1. Remove the 7/16 hex head screw from underside
of pre-assembled burner. See Fig. 1.
2. Install the burner assembly into the heater's case
assembly. See Fig. 2.
a. The burner head must be located between upright
tabs in heater's base.
b. Align tapped hole in burner casting (previously oc-
cupied by hex head bolt) to mounting hole in base.
c. Using a 7/16 in. nut driver or ratchet with 7/16 in.
socket, securely fasten the burner assembly to the
base using the screw removed in step 1.
3. Norseman 200 heaters: Push female terminal on
electrode wire securely onto male terminal of push
button igniter. See Fig. 2.
FIG. 1
7/16 SCREW
FIG. 2
UPRIGHT
TABS
NORSEMAN 200:
ELECTRODE LEAD
CONNECTED TO
PUSH BUTTON
IGNITER
Owner's Manual • Workman & Norseman
Hose and Regulator
Assembly
Propane Gas Heaters
1. Apply a small amount of pipe thread sealant to
threads of rigid hose connection. Connect this end
to to regulator outlet. See Fig. 3. Tighten securely.
Workman 225 shown.
2. Connect opposite end of hose with nut to safety
control valve of heater. See Fig.4. Tighten securely.
(Workman 225 Plus shown.)
FIG. 3
APPLY SEALANT
FIG. 4
NORSEMAN 200:
HOLE IN BAFFLE
PLATE
7/16 IN. BURNER
SCREW
NUT HAS LEFT
HANDED THREADS
NOTE:
Norseman 200 & Norseman
250 heaters use a hose with
swivel nuts at both ends.
• Connect one end to safety
control valve at heater.
• Connect opposite end to
hose adapter at regulator
outlet.