Table of Contents
Advertisement
ESC Programming Procedure
1. Pull and hold the Throttle Trigger to full throttle and turn
the ESC on.
2. After 2 seconds a "-B-B" will sound. Wait another 5
seconds and the ESC will give a rising tone to indicate you
have entered Programming Mode.
3. After entering Programming Mode, you will hear 4 tones
in a loop to indicate Programmable Items. Push the
Throttle Trigger to full brake within 3 seconds to select the
programmable item.
The black-shaded setting is the factory default
Programmable Items
Running Mode -B
Li-Po Cells -B-B
Low Voltage Cutoff -B-B-B
Timing -B-B-B-B
Motor Care
Brushless motors are maintenance free; however, the
bearings that support the rotating portion of the motor
require regular service.
Tip: Removing the motor can make servicing it easier.
1. Remove the cage (see Removing the Cage).
2. Replace the propeller (see Replacing the Propeller).
3. Use water displacement fluid on the motor bearings to
flush any water from the motor compartment.
4. Apply 1–2 drops of Dynamite Precision Oiler on the front
and rear bearings, one at a time.
5. Turn the motor by hand to allow the oil to work its way
into the ball bearing through the bearing seal.
6. Install the propeller and cage in reverse.
Tip: Preventing overheating conditions will prolong motor life.
Removing the Cage
To remove the boat cage:
NOTICE: Carelessly removing the cage from the hull may
sever the wire that powers the LED mounted to the cage.
1. Disconnect and remove the battery from the boat.
2. Secure the boat with one hand and carefully lift the cage
from the hull.
3. Disengage the 10 cage posts from their base and carefully
remove the remainder of the cage.
Tip: If you need to remove the cage, disconnect the LED
wire from the receiver. Use a 2mm hex driver to remove
the 4 screws securing the electronics cover.
4. To reinstall the cage, follow the instructions in reverse.
INSTRUCTION MANUAL
Programmable Value
-B
-B-B
Forward/
Forward Only
Backward
Auto Calc.
2s
None
2.8V/Cell
0.00º
3.75º
4. After selecting a programmable item, you will hear several
tones in a loop to indicate Programmable Values. Pull
Throttle Trigger to full throttle to select the value matching
the tone. The ESC will give an alternating tone to indicate
the item is selected.
5. Keep the Throttle Trigger at Full Throttle to return to Step
3 and continue item selection. Move the Throttle Trigger
to full brake position within 2 seconds to exit the Program
Mode.
-B-B-B
-B-B-B-B
3s
4s
3.0V/Cell
3.2V/Cell
3.4V/Cell
7 .50º
11.25º
15.00º
-B Single Beep
B–– Long Beep
B––
B––
B––
-B
-B-B
5s
6s
18.75º
22.50º
EN
B––
-B-B-B
26.25º
9
Advertisement
Table of Contents
