• Drain any water that has collected in the hull by removing the continue to drip for a few hours. drain plug or canopy and tilting the boat in the appropriate direction to drain the water. Sonicwake™ Self-Righting Deep-V Brushless RTR...
Keep the end of the antenna above the boat’s waterline to get the best transmitter reception. Apply clear tape (DYNM0102), if desired. NOTICE: Do not cut or kink the receiver antenna or damage may result. Sonicwake™ Self-Righting Deep-V Brushless RTR...
Low Voltage Cutoff (LVC) Disconnect and remove the Li-Po battery from the boat after use to prevent trickle discharge. Charge your Li-Po battery to The factory default setting for the LVC in the ESC included with half capacity before storage. During storage, make sure the your boat is set at 3.2V per cell.
NOTICE: Using a larger propeller, or one with more pitch than the one included (on 6S [22.2v]), may damage the 6. Remove the hatch before storing your boat. electronics and battery packs. Sonicwake™ Self-Righting Deep-V Brushless RTR...
Boating Tips During the first run, we recommend calm wind and water NOTICE: When running at full speed in choppy water, the conditions to ensure that the boat is properly set up. propeller may exit and re-enter the water repeatedly and very Maximum speeds of 50 MPH/+ can be achieved once you quickly, subjecting the propeller and drive shaft to some stress.
2. To adjust the angle of the trim tab, carefully bend the the boat to shore for inspection. tab past the ruler. Use a second ruler or depth gauge to measure how much you have bent the tab past the first ruler. Sonicwake™ Self-Righting Deep-V Brushless RTR...
Drivetrain Lubrication Always replace the drivetrain parts when they are damaged or NOTICE: Ensure the flex shaft is installed correctly. Installing show visible wear or injury and damage may result. the flex shaft incorrectly may result in irreparable damage to the boat.
Electronic Speed Control (ESC) Programming STEP 3: Set Item Value After selecting a programmable item, you will hear several STEP 1: Enter Program Mode tones in a loop. 1. Power on the transmitter and set the throttle to full. 1. Move the throttle to full to select the value matching the 2.
Further, in no event shall the liability of Horizon exceed the individual reached during business hours. When sending product into Horizon, price of the Product on which liability is asserted. As Horizon has Sonicwake™ Self-Righting Deep-V Brushless RTR...
please include your RMA number, a list of the included items, and a By submitting the item for service you are agreeing to payment of brief summary of the problem. A copy of your original sales receipt the service without notification. Service estimates are available upon must be included for warranty consideration.
Marineklebeband 18 m (18M) (18M) Dynamite Startup Werkzeugset: DYNT0502 Start Up Tool Set: Proboat Proboat - Set d’outils de démarrage Start Up Tool Set: Proboat Pro Boat Dynamite LED Programmierkarte: Carte de programmation à DELs Dynamite scheda programmazione DYNS3005 Dynamite LED Program Card...