Section 6: Handling Adjustment; Section 7: Speed Control Programming; Section 8: Maintenance - ProBoat Apache 24 Owner's Manual

Operate your Apache 24 in low to medium wake
conditions to avoid having problems with the boat
overturning. If the conditions are questionable,
adjust the prop strut down a bit to reduce the
likelihood of having the boat overturn.
The ESC in your Apache 24 is pre-programmed
from the factory. The following has been provided
if you happen to need to reset the programming of
your ESC.
1. Turn on the transmitter's power switch. Be sure
the transmitter batteries are fully charged.
2. Place the boat in position to allow the propeller
to move freely or disconnect one of the motor
wires from the motor.
3. Turn on the receiver switch. Move the throttle
trigger (stick) to full throttle, then to full
reverse. The ESC will automatically memorize
the initial movement of the throttle channel each
time the receiver switch is turned on.
Before and at the end of each run, make sure
all screws are tight and the propeller is free from
any entanglement.

Section 6: Handling Adjustment

Loosen to Adjust
Outdrive

Section 7: Speed Control Programming

Section 8: Maintenance

You may also turn the dual rate dial down to
reduce rudder travel in rough water conditions.
4. To reset the maximum throttle setting, simply
turn the ESC's power switch off then on and
move the throttle stick to full movements again.
5. When operation is complete, turn off the
receiver, then the transmitter.
Note: Do not turn off the
transmitter first or the receiver
may pick up stray signals and run
out of control.
7
Steering Dual Rate