Table of Contents
Advertisement
EN
ESC Programing
1. Pull and hold the Throttle Trigger to full throttle and
turn the ESC on.
2. After 2 seconds a "-B-B" will sound. Wait another 5
seconds and the ESC will give a rising tone to indicate
you have entered Programming Mode.
3. After entering Programming Mode, you will hear 4
tones in a loop indicating Programmable Items. Push
the Throttle Trigger to full brake within 3 seconds
after the tone sounds matching the programmable
item you want to select.
The black-shaded setting is the factory default
Programmable Items
Running Mode -B
Li-Po Cells -B-B
Low Voltage Cutoff
-B-B-B
Timing -B-B-B-B
Throttle Range Calibration
1. Power on the transmitter and set the throttle TRIM
dial to the center position.
2. Install the batteries in the boat and connect the
batteries to the ESC.
3. With the ESC powered off, pull the throttle trigger to
full throttle and press the power buttons on both ESC
simultaneously. The ESC will beep twice. The green
light will flash with each beep.
12
Programmable Value
-B
-B-B
-B-B-B
Forward
Forward/
Only
Backward
Auto
2s
Calc.
None
2.8V/Cell
3.0V/Cell
0.00º
3.75º
4. After selecting a programmable item, you will hear
several tones in a loop indicating Programmable
Values. Pull Throttle Trigger to full throttle to select
the value matching the tone. The ESC will give an
alternating tone to indicate the item is selected.
5. Keep the trigger in Full Throttle to return to Step 3 and
continue item selection. Move the throttle stick to full
brake position within 2 seconds to exit the Program
Mode.
-B-B-B-B
B––
3s
4s
5s
3.2V/Cell
3.4V/Cell
7 .50º
11.25º
15.00º
4. Return the throttle to neutral. The ESC will beep once
and the green light will flash once.
The calibration process is now complete. The ESC will
arm with beeps and flashes to announce the number
of battery cells it has detected. Reverse calibration is
unnecessary.
-B Single Beep
B–– Long Beep
B––
B––
B––
-B
-B-B
-B-B-B
6s
18.75º
22.50º
26.25º
ShockWave
®
26
Advertisement
Table of Contents
