Schwinn 170 Service Manual page 21

Disconnect all power to the machine before you service it.
!
Note: Your machine may not match the image. For reference only.
1. Remove screws that attach Console to the Mast. Carefully lift the
Console off the Mast.
2. Disconnect the Data Cable and Heart Rate Cable from the back of the
Console. Discard the Console and screws.
Note: Do not let the cables fall down inside the Mast. This step may
require two people.
3. Installation is the reverse procedure.
4. Discard the old parts.
5. Inspect your machine to ensure that all hardware is tight and
components are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner's Manual.
Initial Setup
During the first power-up, the Console should be set up with the date, time
and your preferred measurement units.
1. Date: Push the Increase/Decrease buttons to adjust the currently active
value (flashing). Push the Left/Right buttons to change which segment is
the currently active value (month / day / year).
2. Push OK to set.
3. Time: Push the Increase/Decrease buttons to adjust the currently active
value (flashing). Push the Left/Right buttons to change which segment is
the currently active value (hour / minute / AM or PM).
4. Push OK to set.
5. Units of Measurement: Push the Increase/Decrease buttons to adjust
between "MILES" (Imperial English) or "KM" (metric).
6. Push OK to set.
7. The Console display shows the Machine Type prompt with the current
setting. This menu option appears in the x30 series console only (not the
x70 series consoles). Push the Increase/Decrease buttons to change
between "BIKE" and Elliptical ("ELIP").
8. Push OK to set. The Console goes back to the Power-Up / Idle Mode
screen.
Note: To adjust these selections, consult the "Console Service
Mode" section.
130 / 170
230 / 270
21