Console Service Mode - Schwinn 170 Service Manual

Console Setup Mode – 170 / 270 series (MY17) Console
The Console Setup Mode lets you input the date and time, set the units of measurement to either English or Metric,
control the sound settings ( on/ off), or see maintenance statistics (Total Run Hours – for service technician use only).
1. Hold down the PAUSE/END button and Right button together for 3 seconds while in the Power-Up Mode to go into
the Console Setup Mode.
Note: Push PAUSE/END to exit the Console Setup Mode and return to the Power-Up Mode screen.
2. The Console display shows the Date prompt with the current setting. To change, push the Increase/Decrease buttons
to adjust the currently active value (flashing). Push the Left/Right buttons to change which segment is the currently
active value (month / day / year).
3. Push OK to set.
4. The Console display shows the Time prompt with the current setting. Push the Increase/Decrease buttons to adjust
the currently active value (flashing). Push the Left/Right buttons to change which segment is the currently active value
(hour / minute / AM or PM).
5. Push OK to set.
6. The Console display shows the Units prompt with the current setting. To change, push OK to start the Units option.
Push the Increase/Decrease buttons to change between "MILES" (Imperial English units) and "KM" (metric units).
Note: I f the units change when there is data in User Statistics, the statistics convert to the new units.
7. Push OK to set.
8. The Console display shows the Sound Settings prompt with the current setting. Push the Increase/Decrease buttons
to change between "ON" and "OFF".
9. Push OK to set.
10. The Console display shows the TOTAL RUN HOURS for the machine.
To go to the next Console Setup Mode prompt, push the OK button. (Go to step 11.)
11. The Console display shows the Software Version prompt. Push OK to go to the next prompt.
12. READING BLE – The Console display shows the Bluetooth
13. DISCONNECT BLE_NO – Push the Increase/Decrease buttons to adjust the value (NO/YES). Push OK to set.
14. VIEW ERROR MSG_NO – Push the Increase/Decrease buttons to adjust the value (NO/YES). Push OK to set.
15. RESET CONSOLE_NO – This option resets the data from user inputs. Push the Increase/Decrease buttons to adjust
the value (NO/YES). If YES is selected, the Console setup, user records and workout records will be reset to defaults.
This option does not reset MFG NVM (non volatile memory).
16 . The Console will display the Power-Up Mode screen.
Console Service Mode – 170 / 270 series (MY17) Console
SERVICE MODE is a sub-menu from the CONSOLE SETUP MODE. Most of the options contained within the Service
Mode are for Service Technicians and should not need to be used by a user.
To access the Engineering Mode:
1. From the Power Up (or Welcome) screen, push and hold down the PAUSE/STOP button and Right arrow button for
about 5 seconds to go into the Console Setup Mode. The Console display will show the Date prompt with the current
setting.
Note: Push PAUSE/STOP to exit the Console Setup Mode and return to the Power-Up Mode screen.
2. Push the OK button 4 times until the Console displays the TOTAL RUN HOURS screen.
3. T o enter the Manufacturing Menu (MFG Menu), hold down the PAUSE/END button and Right button together for 3
seconds. The Console display shows the Firmware Version string. Push the Up/Down buttons to move through the
MFG Menu options. Push OK to make a selection.
a. E NTER MFG TEST – This option is intended for use on the manufacturing production line only. It is a chained
series of tests similar to the tests listed below, but optimized to be run on the production line. Use of this chained
test should not be necessary anywhere but on the production line.
reading string.
®
9