Table of Contents
Advertisement
WARNING
INSTALLATION STEP 6
CAUTION
Install the Door Control
Locate the door control within sight of the door at a
minimum height of 1.5m where small children cannot
reach, and away from all moving parts of the door
and door hardware.
1. Strip 6.35mm of insulation from one end of the bell
AVERTISSEMENT
wire. Connect it to the two screw terminals on the
back of the door control by color: white wire to 2
and white/red wire to 1.
ATTENTION
2. Fasten the Lighted Door Control Button securely
with 6AB x 38mm screws. If installing into drywall,
drill 4mm holes and use the anchors provided.
3. Run the bell wire up the wall and across the
ceiling to the opener. Use insulated staples to
secure the wire in several places. Be careful not to
pierce the wire with a staple, creating a short or
open circuit.
4. Receiver terminal screws and the antenna are
located on the back panel of the motor unit.
Position the antenna wire as shown.
5. Then connect the bell wire to the opener terminal
screws: white to 2 and white/red to 1.
6. Use tacks or staples to permanently attach the
entrapment warning label to the wall near the door
control, and the manual release/safety reverse test
in a prominent location on the inside of the garage
door.
NOTE: DO NOT connect the power and operate the
opener at this time.
-2
-1
WIRING INSTRUCTIONS FOR
ACCESSORIES
• Place entrapment warning label on the inside of
door as a reminder of safe operating procedures.
Place the manual release/safety reverse test
label in plain view on the inside of the garage
door.
114A2558F
Bell Wire
Lighted Door
Control Button
Terminal Screws
To prevent possible SERIOUS INJURY or DEATH from
electrocution:
• Be sure power is not connected BEFORE installing door
control.
• Connect ONLY to 24 VOLT low voltage wires.
To prevent possible SERIOUS INJURY or DEATH from a
AVERTISSEMENT
closing garage door:
• Install door control within sight of garage door, out of
reach of children at a minimum height of 1.5m, and
away from all moving parts of door.
AVERTISSEMENT
• NEVER permit children to operate or play with door
control push buttons or remote control transmitters.
• Activate door ONLY when it can be seen clearly, is
properly adjusted, and there are no obstructions to door
travel.
• ALWAYS keep garage door in sight until completely
closed. NEVER permit anyone to cross path of closing
garage door.
HARDWARE SHOWN ACTUAL SIZE
Screw 6AB x 38mm
Lighted Door Control Button
Bell Wire
BACK PANEL
Lighted
Door Control Button
KEY SWITCH MODEL 059009
To opener terminal screws: white to 2; white/red to 1.
SAFETY INFRA-RED BEAMS MODEL 062153
To opener terminal screws: white to 2; Black to 3.
DOOR CONTROL PANEL 062159
To opener terminal screws: white to 2; white/red to 1.
18
WARNING
WARNING
Insulated
Dry Wall Anchors
Staples
Opener
Terminal Screws
1
2
3
9
9
1
7
3
7
5
5
Kg
Kg
Antenna
1
3
Hide quick links:
Advertisement
Table of Contents
