Table of Contents
Advertisement
WISE Colibri Ceiling
Other risk
When the product is voltage fed, the damper
will either open or close, there can be a certain
risk for pinch injuries, for example, on the fin-
gers if these are placed between the damper
blade.
Handling
Always use appropriate transport and lifting devices when
the product is to be handled to reduce ergonomic loads.
The product must be handled with care.
2
Swegon reserves the right to alter specifications.
Installation
• Moist, cold and aggressive environments must be
avoided.
• Avoid installing the product above/near a heat source,
for example, luminaires.
• Assemble the product according to applicable industry
regulations.
• Install the product so that it is not accessible by unau-
thorized persons, for example in a suspended ceiling.
• Install the product for easy access during service/main-
tenance.
• If the product is mounted in a fixed ceiling, the inspec-
tion hatch must be located so that the product is acces-
sible for inspection.
• If the product is mounted in cold areas, the commis-
sioning box must be insulated on the outside against
condensation.
• The product must be installed horizontally.
• It is recommended to mount the product so that the
product's damper front can be opened.
• The product must be laid down prior to installation so
that it cannot fall over.
• Check to make sure that the product does not have
any visible defects.
• Check that the product is properly secured after it has
been installed.
• Use the product's eyes to secure the cables with cable
ties.
• Check that all cables are properly secured in place after
installation.
20181012
Advertisement
Table of Contents
