Advertisement
Cle a douille
La cle a douille se trouve a 'emplace-
ment que montre la figure. Pour l'utiliser,
retirez-la du porte-cle. Apres usage, re-
mettez-la sur le porte-cle.
(i) cie a
douille
(2) Porte
-
cle
Montage sur etabli
Cet outil doit etre fixe al'aide de deux
boulons sur une surface plate et stable,
grace aux trout de boulon
que
comporte
sa base. Ceci afin d'eviter le basculage
et
d'eventuelles blessu
res.
(11 BouIon
Socket
w
rench
8
The socket wrench is stored as shown in
the figure. When using the socket wrench,
pull it out of the wrench holder. After
using the socket wrench, return it to the
wrench holder.
11) Socket wrench
12) Wrench holder
Bench mounting saw
This tool should be bolted with two bolts
to a level and stable surface using the bolt
holes provided in the tool's base. This will
help prevent tipping and possible injury.
(11 Bolt
Pose et depose de la lame
ATTENTION:
Avant d'installer ou de retirer la lame de l'outil, assurez-vous
toujours que l'outil est debrache et le contact coupe.
L'outil est expedie avec le bras verrouille
en position basse. Pour le relacher, abais-
sez-le legerement et retirez la chaine de la
vis sous le carter du moteur,
A l'aide de la cle a douille, relachez le
boulon hexagonal maintenant le carter
central en le tournant vers la gauche.
Soulevez le carter de securite et le carter
central.
(1) Boulon hexagonal
121 Carter central
(3) CIA A douille
141 Carter de securite
Installing or removing saw blade
CAUTION:
Always be sure that the tool is switched off and unplugged be-
fore installing or removing the blade.
When the tool is shipped, the handle is
locked in the lowered position. Release
the handle from the lowered position by
lowering the handle slightly and removing
the chain from the screw under the motor
housing.
Use the socket wrench to loosen the hex
bolt holding the center cover by turn.
ing it counterclockwise. Raise the safety
cover and center cover.
(1) Hex bolt
(2) Center cover
(3) Socket wrench
14)
Safety cover
9
Advertisement
