Table of Contents
Advertisement
2.9
Taking Measurements
For the highest accuracy, calibrate the sensor(s) before taking measurements.
1. Create Site and Data ID lists for logged data (if applicable).
2. Set the logging method (single or interval).
3. Set the Auto Stable parameters (if applicable).
4. Verify that the sensors and/or port plugs are correctly installed in all bulkhead ports.
5. Install the probe guard.
6. Insert the probe into the sample. Make sure the probe is fully submerged.
7. Move the probe in the sample to release any air bubbles and to provide a fresh sample to the sensors.
8. Wait for the sensor/s to stabilize in the sample.
9. On the main run screen, press
NOTE: An option to change Site and/or Data ID (if enabled) appears once
10. To stop continuous logging, simply press
Operation
ENTER
to begin logging (single or interval) (See Logging).
ENTER
key again.
is pressed to begin logging.
ENTER
29
Advertisement
Table of Contents
