Terminal Block Connector Pinout - Planet WGS-804HPT Quick Installation Manual

3.1 Terminal Block Connector Pinout

To install the 3-pin Terminal Block Connector on the Wall-mount Managed Switch,
simply follow the following steps:
Step 1: Insert positive DC power wire into V+, negative DC power wire into V-,
and grounding wire into Ground.
Step 2: Tighten the wire-clamp screws for preventing the wires from loosening
and plug into the Wall-mount Managed switch.
1. The wire gauge should be in the range from 12 to 24 AWG.
2. The device must be grounded.
Note
6
Ground
V
-
V+