Step 4 Install Wings - Kargo Master 4064M Installation Manual

Step 3 – Prepare "B" Pillar Con't
• Align and square partition to your liking.
• Press wings firmly against "B" pillar.
• Mark holes along each wing (3x each) and the
outer edge of the wing along each "B" pillar.
• Remove partition with wings from van.
• Prior to drilling or cutting, pry plastic away to
expose underside, ENSURE IT IS SAFE TO DRILL.
• Cut away plastic on "B" pillar to expose
corresponding holes along the metal "B" pillar.
• Option 1, Use a 1" holesaw where holes were
marked.
• Option 2, Cut along edge of wing to expose
more of the metal "B" pillar. This option tends
to make for an easier installation.
Step 4 – Install Wings
• Locate the holes that
correspond with the wings
along the metal "B" pillar.
These holes will be where
the arrows are shown in
Step 3.
• Drill these 3 holes on each
pillar using a 25/64" bit.
• Install RivNut.
• Bolt wings to previously
installed RivNuts using 1/4"
x 1.5" or 2" HH (1 or 2),
1/4" lock washer (4), 1/4"
flat washer (5), two 3/8"
spacers (8) and a retaining
washer (6) in the order
shown.
• Repeat on both sides, for a total of 6x.
• Snug Tighten, But allow movement.
For Technical Support Call: 800-343-7486 Monday-Friday 7AM - 4 PM (PST)
Install Instructions – 4064M
Page 6