RoboLabs ROBOJETFLOSS Operation Manual page 21

necessary equipment and tools to do this.
To replace the brush units (25) the following should be done.
Remove the screws fixing the brush unit. Take off the unit carefully. Inspect
the carbon brushes. If brushes are worn more than for a half of the length,
they should be replaced.
ATTENTION! ONCE BRUSH UNITS REPLACED, CLEAN THE SLIP
RINGS (24) SURFACE OF TARNISH, DUST AND SO ON.
Let the motor spin for about 15 minutes before turn on the heating. It allows
the brushes to adapt to slip rings, avoiding possible sparkling during brush
friction.
3.4. PRESERVATION
In case of prolonged period of no use all the technical maintenance routine
must be done.
COTTON CANDY MACHINE ACB-09E REVISED 28-Sep-17
21