Unit Start-Up Checklist; Safety Considerations - Carrier 40UV075 Installation, Start-Up And Service Instructions Manual

NOTE: To avoid injury to personnel and damage to equipment or prop-
erty when completing the procedures listed in this start-up checklist,
use good judgment, follow safe practices, and adhere to the safety
considerations/information as outlined in preceding sections of this
Installation, Start-Up, and Service document.
MODEL NO.: _________________________________
SOFTWARE VERSION _________________________
DATE: _______________________________________
INITIAL CHECKLIST:
 DOES ELECTRICAL SERVICE CORRESPOND TO UNIT NAMEPLATE?
 ARE ALL ELECTRICAL CONNECTIONS TIGHT?
 DOES ALL FIELD WIRING CONFORM TO UNIT WIRING DIAGRAM?
 IS UNIT INSTALLED PER IOM (LEVEL, CABINET PAINT CONDITION ACCEPTABLE, ETC.)?
 IS THE CONDENSATE DISPOSAL SYSTEM OPERATING CORRECTLY?
 PROPER SLOPE OF FIELD REVERSIBLE DRAIN PAN?
 ARE END BEARING BOLTS ON FAN SHAFT TIGHT?
 ARE DAMPERS OPERATING PROPERLY?
 IS THE FILTER CLEAN?
 IS EXPANSION VALVE BULB PROPERLY INSTALLED AND INSULATED?
PIPING CHECKLIST:
 IS EXPANSION VALVE BULB PROPERLY INSTALLED AND INSULATED?
 IS UNIT PIPING CORRECT AND INSULATED TO PREVENT CONDENSATION?
 ARE THE CONTROL VALVE PACKAGES PIPED CORRECTLY?
 ARE VALVE PACKAGES PROPERLY INSULATED?
 ARE THERE ANY LEAKS DETECTED?
CONTROLS CHECKLIST:
 DOES THE UNIT HAVE CARRIER CONTROLS (CCN OR OPN)? IF SO, CONTINUE.
 CHECK THAT THE UNIT OPERATES PER SEQUENCE OFOPERATION AS STATED IN THE CONTROLLER IOM.
 RECORD THE THERMOSTAT READINGS IN TABLE BELOW.
Please Fill Out the Following:
Space Temperature
Discharge Air Temperature
Outdoor Air Temperature
Outdoor Air Damper Position
Space Setpoint
Unoccupied Offset
Minimum Position
Deadband
Outdoor Air Damper
Face/Bypass Damper
Manufacturer reserves the right to discontinue, or change at any time, specifications or designs without notice and without incurring obligations.
Catalog No. 04-53400048-01

UNIT START-UP CHECKLIST

Controller Points
Position (Open / Closed / %)
Printed in U.S.A. Form 40UV-UH-11SI
SERIAL NO.: _____________________________________
TECHNICIAN: ____________________________________
Set Points
Pg CL-1
Reading
8-18 Replaces: 40UV-UH-10SI