Marcy ME-1019R Owner's Manual page 17

36 Bearing
37 Bearing
38 Copper washer
COMPUTER
FUNCTIONAL BUTTONS:
MODE - Push down for selecting functions.
SET - To set the time, distance, calories and hand pulse.
RESET - For resetting time, distance, calories and hand pulse.
FUNCTION AND OPERATIONS:
1. SCAN: Press "MODE" button until "SCAN" appears, monitor will cycle through all the 6
functions: Time, speed, distance, calorie ODO and pulse. Each function will display for 6
seconds.
2.TIME: (1) Count the total time of exercise from start to end.
(2) Press "MODE" button until "TIME" appears, press "SET" button to set exercise time.
When the "set" is zero, the computer will sound an alarm for 15 seconds.
3.SPEED: Display current speed.
4. DIST: (1) Count the distance of exercise from start to end.
(2) Press "MODE" button until "DIST" appears. Press "SET" button to set exercise
distance. When the "set" is zero, the computer will sound an alarm for 15 seconds.
5.CALORIES: (1) Count the total calories of exercise from start to end.
(2) Press "MODE" button unit "CAL" appears. Press "SET" button to set
exercise calories. When the "set" is zero, the computer will sound an alarm for
15 seconds.
6. ODO： Monitor will display the total accumulated distance.
7. PULSE: Press MODE button until "PULSE" appears. Before measuring your pulse rate, please
place the palms of your hands on both contact pads and the monitor will show your
current heart beat rate in beats per minute(BPM) on the LCD after 6~7 seconds.
Note: During the pulse measurement, the measured value may be higher than the
actual pulse rate during the first 2~3 seconds, then will return to normal level. The
PULSE Function value cannot be regarded as the basis of medical treatment.
Press "MODE" button until "PULSE" appears. Press "SET" button to set exercise pulse.
The setting values of 40-240 RPM , the computer will sound alarm when heart rate is
below the SET value.
© Impex Inc.
1 74 Stationary handlebar L/R
3 75 Aircraft nut M8
1 76 Grommet
16
1/1
2
1
www.marcypro.com