Marcy ME-1019R Owner's Manual page 12

STEP 5
1. Attach the rear handlebar (#22) to the seat support bracket (#25). Secure using two carriage bolts
(31), two curved washers (#9) and two domed nuts (#33).
2. Connect the rear extension hand pulse wire (#64) to the hand pulse wire (#65) on the rear handlebar.
Tip: Avoid pinching the pulse Wires
3. Attach the left stationary handlebar (#74L) to the front post (#4). Secure using two curved washers
(#9) and two Allen bolts (#8). Repeat for the right stationary handlebar (#74R).
4. Connect the front extension hand pulse wire (#60) to the pulse wire form the computer (#2)
5. Connect the upper extension sensor wire (#10) to the wire from the computer (#2).
Tip: Avoid pinching the Extension Wires and pulse wires
6. Attach the computer (#2) to the top bracket of front post (#4). Secure using four screws (#3) which
are pre-assembled on the back of computer.
7. Thread the Left Pedal (
8. Thread the Right Pedal (
74L
8
9
17L
© Impex Inc.
17L) counterclockwise into the Crank (
#
17R) clockwise into the Crank (
#
2
74R
3
60
10
4
17R
21
9
8
25
64
11
21).
#
21) on the other side.
#
31
22
www.marcypro.com
65
9
33