Unit Identification Over Ip Network - Axis T8504-E User Manual

AXIS T8504–E Outdoor PoE Switch
General information
PC IPv4 address: 192.168.0.40
PC IPv4 mask: 255.255.255.0
2. Connect your PC Ethernet network interface to any of the unit's Ethernet ports.
3. Open a web browser and type 192.168.0.254 in the address field.
4. Log in with the default username and password. See Default unit IP, username and password on page 6 .
5. Configure the unit. It is recommended to change the usernames and passwords to other than the default values.

Unit identification over IP network

To locate the unit over the IP network, the unit sends IPv4 SysLog message #0 in broadcast format 255.255.255.255 upon power-up.
Any SysLog server connected over LAN receives this SysLog message. The same SysLog message is also sent to the optional SysLog
servers 1 and 2, if they are configured.
The unit sends the message twice. This is to ensure that the SysLog message is received by the SysLog servers, regardless of network
configuration. The message is first sent before VLAN configuration is made and later again after VLAN configuration is done.
SysLog message #0 contains all the information which is required to be able to provide access to the unit over the network.
Example: MsgID#000 - System UP. APP:v3.51.06 BOOT:v3.16 RST:Power-On BOOT:0=[APP
OK] Host:axis-00055A034B49 MAC:00:05:5a:03:4b:49 VLAN:YES VLAN_MNGR:5
VLAN_UPLINK_PORT:3 VLAN_UPLINK_MODE:TRUNK DHCPv4:No IP1v4:192.168.0.254/24 DHCPv6:No
IP1v6:2345::205:5AFF:FE03:4B49/64 IP2v6:FE80::205:5AFF:FE03:4B49/64
Field
MsgID#000 - System UP
APP:
BOOT:
RST:
BOOT:
Host:
MAC:
VLAN:
VLAN_UPLINK_PORT:
VLAN_UPLINK_MODE:
DHCPv4:
IP1v4:
DHCPv6:
IP1v6:
IP2v6:
Value
v3.51.06
v3.16
Power-On
0=[APP OK]
axis-00055A034B49
00:05:5a:03:4b:49
YES
3
TRUNK
No
192.168.0.254/24
No
2345::205:5AFF:FE03:4B49/64
FE80::205:5AFF:FE03:4B49/64
8
Description
SysLog message number
Unit application software version
Unit boot version, used for software
update
Reset reason
axis followed by unit MAC address
Unit MAC address
VLAN status enabled or disabled
Ethernet port number used for unit
management
Management port is configured as Access
or Trunk
DHCPv4 Yes or No
Unit IPv4 address
DHCPv6 Yes or No
Unit IPv6 address
Unit link-local IPv6 address