General Information; Features; User Access And Security - Axis T8504-E User Manual

AXIS T8504–E Outdoor PoE Switch

General information

General information

Features

A number of features are provided through system network management.
• Easy software update during runtime without affecting active PoE ports
• Configuration and real-time monitoring using graphical representation of the remote device
• System status display
• SysLog reporting on PoE events, invalid remote user access, initial DHCPv4/v6 address etc.
• SNMP traps reporting on various PoE events such as PoE powered device insertion or removal
Ethernet switch network capabilities
• Four weather sealed RJ45 Ethernet ports capable of 10 Mbit, 100 Mbit, 1000 Mbit half-duplex and 1000 Mbit full-duplex
Ethernet speed
• Single weather sealed SFP Ethernet port
• 8K internal MAC address lookup engine
• VLAN — Access, Trunk and Filtered trunk
• Auto MDIX
• 10KB jumbo frames
PoE capabilities
The following PoE options are available:
• Two 4Pair PoE ports which deliver up to 60 W per port
• Two IEEE 802.3at PoE ports which deliver up to 30 W per port
• PoE enable/disable to enable or disable PoE ports power output. Ethernet data is always enabled.
• Remote device reset to reset attached powered device. The device is temporarily powered off and then turned back on.
Supported network protocols
The following network protocols are supported:
• IPv4 – 32–bit long IP address (static/DHCPv4)
• IPv6 – 128–bit long IP address (static/DHCPv6)
• VLAN – Access, Trunk and Filtered trunk

User access and security

Access options
You can access the unit through different interfaces:
• Web interface via a web browser – to view the unit PoE status, network status, unit configuration and unit production
information
5