Receiver Problems - Topcon HiPer Lite Operator's Manual

Receiver Problems

The following are some of the most commonly encountered
receiver problems.
Problem
The receiver cannot establish a connection to a computer or
external controller.
Causes
The cable is not
properly plugged in.
The cable is damaged
The receiver port used
for connection is not in
Command mode.
1-866-4TOPCON
Solutions
• Check that the cable connector is
attached to the correct serial port.
• Unplug the cable, then securely and
properly reconnect it to the receiver.
• See "External Components"on
page 1-12 and "Connector
Specifications" on page A-9 for
information on the receiver's
connectors.
Use an undamaged cable. Contact your
Dealer to replace the cable.
1. Connect your receiver and a
computer using a free port (see
"Connecting the HiPer Lite and a
Computer" on page 2-4) and start
PC-CDU.
2. Click Configuration->Receiver
->Ports.
3. Change the Input for the serial port
used for connection to Command.
Receiver Problems
www.topconpositioning.com
5-3