Using Minter To Clear Nvram; Using Pc-Cdu To Clear Nvram - Topcon HiPer Lite Operator's Manual

Operation
In addition, the NVRAM keeps information about the receiver file
system. Note that after clearing the NVRAM, the receiver's STAT
LED will flash orange for a few seconds indicating that the receiver
is scanning and checking the file system. Firmware versions 2.2p1
or higher keep the spread spectrum modem on after clearing the
NVRAM.
Clear the NVRAM using the MINTER or PC-CDU.

Using MINTER to Clear NVRAM

1. Press the power key to turn off the receiver.
2. Press and hold the FN key.
3. Press and hold the power key for about one second.
Release the power key while continuing to hold the FN
key.
4. Wait until the STAT and REC LEDs are green
5. Wait until the STAT and REC LEDs blink orange.
6. Release the FN key while the STAT and REC LEDs blink
orange.

Using PC-CDU to Clear NVRAM

1. Connect your receiver and computer. See "Connecting the
HiPer Lite and a Computer" on page 2-4 for this procedure.
2. Click Tools->Clear NVRAM (Figure 4-14). The REC
LED rapidly flashes green and red; the STAT LED flashes
red.
The receiver will automatically disconnect once the NVRAM is
4-18
cleared.
Topcon
Figure 4-14. Tools->Clear NVRAM
HiPer Lite Operator's Manual