Surveying With The Gms-2 And A Beacon Receiver - Topcon GMS-2Pro Manual

Introduction
6. When you reach a location to record a point, pause and press the
Enter button on the GMS-2. Wait until the point is recorded before
moving to the next location.
Surveying with the GMS-2 and a Beacon
Receiver
1. Complete any required pre-survey steps as described in Chapter 2.
2. Setup the Beacon receiver according to it's documentation.
3. Using BTManager, connect the GMS-2 and GPS receiver as
described in Connecting the GMS-2 and a Bl. In BTManager, the
BR-1 would be considered an "Uncategorized" device.
Figure 3-9. GMS-2 and BR-1 Setup
4. Configure the GMS-2 for data collection as described in the
corresponding software manual.
Ensure the survey configuration is for an external
receiver.
4.
For example, if using TopPAD as the data collection software,
refer to the TopPAD Reference Manual.
5. Via the data collection software, begin logging data.
GMS-2 Operator's Manual
26