Surveying With The Gms-2 And A Beacon Receiver - Topcon GMS-2 Operator's Manual

GMS-2_OM_Book.book Page 7 Friday, December 28, 2007 1:47 PM
Surveying with the GMS-2 and a
Beacon Receiver
1. Complete any required pre-survey steps as described in
Chapter 2.
2. Setup the Beacon receiver according to its documentation.
3. Using BTManager, connect the GMS-2 and GPS receiver as
described in "Connecting the GMS-2 and a Bluetooth Device" on
page 3-3. In BTManager, the BR-1 would be considered an
"Uncategorized" device.
4. Configure the GMS-2 for data collection as described in the
corresponding software manual.
NOTICE
For example, if using TopPAD as the data collection software,
refer to the TopPAD Reference Manual.
5. Via the data collection software, begin logging data.
6. When you reach a location to record a point, pause and press the
Enter button on the GMS-2. Wait until the point is recorded
before moving to the next location.
P/N 7010-0752
Surveying with the GMS-2 (Using GMS Tools)
Connect GMS-2 and
BR-1 Receiver via Bluetooth
Figure 3-7. GMS-2 and BR-1 Setup
Ensure the survey configuration is for an external
receiver.
3-7