Configuration Example: One-Arm Deployment Mode With Vpc - Cisco Nexus 9000 Series Configuration Manual

Configuring ITD

Configuration Example: One-Arm Deployment Mode with vPC

Figure 6: One-Arm Deployment Mode
Step 1: Define the device group.
switch(config)# itd device-group DG
switch(config-device-group)# node ip 210.10.10.11
switch(config-device-group)# node ip 210.10.10.12
switch(config-device-group)# node ip 210.10.10.13
switch(config-device-group)# node ip 210.10.10.14
switch(config-device-group)# probe icmp
Step 2: Define the ITD service.
switch(config)# itd HTTP
switch(config-itd)# ingress interface port-channel 1
switch(config-itd)# device-group DG
switch(config-itd)# no shutdown
Configuration Example: One-Arm Deployment Mode with vPC
The configuration below uses the topology in the following figure:
Cisco Nexus 9000 Series NX-OS Intelligent Traffic Director Configuration Guide, Release 9.x
44