Configuring Itd; Enabling Itd; Configuring A Device Group - Cisco Nexus 9000 Series Configuration Manual

Configuring ITD

Table 2: Default ITD Parameters
Parameters
Probe frequency
Probe retry down count
Probe retry up count
Probe timeout

Configuring ITD

Enabling ITD

Before you can access the ITD commands, you must enable the ITD feature.
Before you begin
Ensure that you have installed the Network Services license.
Ensure that policy-based routing (PBR) is enabled.
Procedure
Step 1
Step 2
Step 3

Configuring a Device Group

You can create an ITD device group and then specify the group's nodes and probe. Beginning with Cisco
NX-OS Release 7.0(3)I3(1), you can configure multiple device groups.
Cisco Nexus 9000 Series NX-OS Intelligent Traffic Director Configuration Guide, Release 9.x
16
Command or Action
configure terminal
Example:
switch# configure terminal
switch(config)#
[no] feature itd
Example:
switch(config)# feature itd
(Optional) copy running-config startup-config
Example:
switch(config)# copy running-config
startup-config
Default
10 seconds
1
1
5 seconds
Purpose
Enters global configuration mode.
Enables the ITD feature. By default, ITD is
disabled.
Copies the running configuration to the startup
configuration.
Configuring ITD