Cisco Nexus 9000 Series Configuration Manual page 71

Configuring ITD
Figure 17: ASA Cluster with Dual-Switch Sandwich with vPC
Step 1: Configure the two switches.
Note The introduction of clustering does not change the ITD configuration. The ITD configuration depends on the
type of topology. In this example, the configuration is the same as in the dual-switch sandwich with vPC
topology.
switch #1:
interface vlan 10
description INSIDE_VLAN
ip address 192.168.10.10/24
interface vlan 100
description FW_INSIDE_VLAN
ip address 192.168.100.10/24
interface port-channel 11
description To_ASA-1_INSIDE
switchport mode access
switchport access vlan 100
vpc 11
interface ethernet 4/1
description To_ASA-1_INSIDE
switchport mode access
Cisco Nexus 9000 Series NX-OS Intelligent Traffic Director Configuration Guide, Release 9.x
Configuration Example: Firewall in Layer 3 Clustering
63