Cisco Nexus 9000 Series Configuration Manual page 45

Configuring ITD
4
test_itd_bucket_4
switch(config)# show run service
!Command: show running-config services
!Time: Tue Sep 20 20:37:14 2016
version 7.0(3)I5(1)
feature itd
itd device-group dg1
probe icmp
node ip 1.1.1.1
node ip 2.1.1.1
node ip 3.1.1.1
node ip 4.1.1.1
itd test
device-group dg1
ingress interface Eth1/11
load-balance method dst ip
access-list acl1
no shut
This example shows how to create an ITD session to nondisruptively delete nodes in the dg1 device group:
switch(config)# feature itd
switch(config)#
switch(config)# itd device-group dg1
switch(config-device-group)#
switch(config-device-group)#
switch(config-dg-node)#
switch(config-dg-node)#
switch(config-dg-node)#
switch(config-dg-node)#
switch(config-dg-node)# itd test
switch(config-itd)#
switch(config-itd)#
switch(config-itd)#
Note: Configure buckets equal or more than the total number of nodes.
switch(config-itd)#
switch(config-itd)#
switch(config-itd)# show itd test
Legend:
ST(Status): ST-Standby,LF-Link Failed,PF-Probe Failed,PD-Peer Down,IA-Inactive
Name
-------------- ---------- -------- -------
test
Exclude ACL
-------------------------------
Device Group
4.1.1.1 Active
Bucket List
--------------------------------------------------------------------------
node ip 2.1.1.1
node ip 3.1.1.1
node ip 4.1.1.1
device-group dg1
ingress interface Eth1/11
load-balance method dst ip
access-list acl1
no shut
LB Scheme Status
dst-ip ACTIVE
Cisco Nexus 9000 Series NX-OS Intelligent Traffic Director Configuration Guide, Release 9.x
1 ICMP
probe icmp
node ip 1.1.1.1
Buckets
4
Probe
Configuration Examples for ITD
OK 6 10006
Port
37