Cisco Nexus 9000 Series Configuration Manual page 41

Configuring ITD
-------------------------------
Device Group
-------------------------------------------------- ----- ------
dg
Pool
------------------------------ ------------ ------ ---------
test_itd_pool
Node
------------------- ------- --- ---- ----- --------------- -- --- -------
1
Node
------------------- ------- --- ---- ----- --------------- -- --- -------
2
Node
------------------- ------- --- ---- ----- --------------- -- --- -------
3
switch#
switch# conf t
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# end
switch#
This example shows how to configure an ITD service to evenly distribute traffic across all available nodes
(rather than to just one active node) after a node failure.
switch# show run services
!Command: show running-config services
!Time: Thu Sep 22 22:30:21 2016
version 7.0(3)I5(1)
feature itd
itd session device-group dg
itd device-group dg
probe icmp
node ip 1.1.1.1
node ip 2.2.2.2
node ip 3.3.3.3
IP Cfg-S
1.1.1.1 Active
Bucket List
--------------------------------------------------------------------------
test_itd_bucket_1, 4
IP Cfg-S
2.2.2.2 Active
Bucket List
--------------------------------------------------------------------------
test_itd_bucket_2
IP Cfg-S
3.3.3.3 Active
Bucket List
--------------------------------------------------------------------------
test_itd_bucket_3
Cisco Nexus 9000 Series NX-OS Intelligent Traffic Director Configuration Guide, Release 9.x
Probe
ICMP
Interface Status Track_id
Eth1/1 UP 1
WGT Probe Port Probe-IP
1 ICMP
WGT Probe Port Probe-IP
1 ICMP
WGT Probe Port Probe-IP
1 ICMP
Configuration Examples for ITD
Port
STS Trk# Sla_id
OK 2 10002
STS Trk# Sla_id
OK 3 10003
STS Trk# Sla_id
PF 4 10004
33