Cisco Nexus 9000 Series Configuration Manual page 43

Configuring ITD
switch(config-dg-node)# itd test
switch(config-itd)#
switch(config-itd)#
switch(config-itd)#
Note: Configure buckets equal or more than the total number of nodes.
switch(config-itd)#
switch(config-itd)#
switch(config-itd)# show itd test
Legend:
ST(Status): ST-Standby,LF-Link Failed,PF-Probe Failed,PD-Peer Down,IA-Inactive
Name
-------------- ---------- -------- -------
test
Exclude ACL
-------------------------------
Device Group
-------------------------------------------------- ----- ------
dg1
Pool
------------------------------ ------------ ------ ---------
test_itd_pool
ACL Name
------------------------------
acl1
Node
------------------- ------- --- ---- ----- --------------- -- --- -------
1
Bucket List
Node
------------------- ------- --- ---- ----- --------------- -- --- -------
2
Node
------------------- ------- --- ---- ----- --------------- -- --- -------
3
switch(config-itd)# show run service
!Command: show running-config services
!Time: Tue Sep 20 20:36:04 2016
version 7.0(3)I5(1)
feature itd
device-group dg1
ingress interface Eth1/11
load-balance method dst ip
access-list acl1
no shut
LB Scheme Status
dst-ip ACTIVE
IP Cfg-S
1.1.1.1 Active
--------------------------------------------------------------------------
test_itd_bucket_1, 4
IP Cfg-S
2.1.1.1 Active
Bucket List
--------------------------------------------------------------------------
test_itd_bucket_2
IP Cfg-S
3.1.1.1 Active
Bucket List
--------------------------------------------------------------------------
test_itd_bucket_3
Cisco Nexus 9000 Series NX-OS Intelligent Traffic Director Configuration Guide, Release 9.x
Buckets
4
Probe
ICMP
Interface Status Track_id
Eth1/11 UP 2
WGT Probe Port Probe-IP
1 ICMP
WGT Probe Port Probe-IP
1 ICMP
WGT Probe Port Probe-IP
1 ICMP
Configuration Examples for ITD
Port
STS Trk# Sla_id
OK 3 10003
STS Trk# Sla_id
OK 4 10004
STS Trk# Sla_id
OK 5 10005
35