Right Handlebar Switches - Triumph Speed Triple S Owner's Handbook Manual

Right Handlebar Switches

Speed Triple S
6
5
4
3
1
1. HOME button
2. Engine start/stop switch
3. START position
4. RUN position
5. STOP position
6. Hazard warning lights switch
The following sections describe the han-
dlebar buttons and switches functions.
HOME Button
The HOME button is used to access the
main menu on the instrument display.
Press and release the HOME button to
select between the main menu and in-
strument display.
Engine Stop Switch
In addition to the ignition switch being
turned to the ON position, the engine
stop switch must be in the RUN position
for the motorcycle to operate.
The engine stop switch is for emergency
use. If an emergency arises which re-
quires the engine to be stopped, move
the engine stop switch to the STOP po-
sition.
Note:
•
2
Do not leave the ignition switch in the
ON position unless the engine is run-
ning as this may cause damage to
electrical components and will dis-
charge the battery.
Starter Button
The starter button operates the electric
starter. For the starter to operate, the
clutch lever must be pulled to the han-
dlebar.
Note:
•
Hazard Warning Lights Button
To turn the hazard warning lights on or
off, press and release the hazard warn-
ing light button.
The ignition must be switched on for the
hazard warnings lights to be activated,
but the hazard lights will remain active
if the ignition is switched off until the
hazard warning light button is pressed
again.
General Information
Although the engine stop switch
stops the engine, it does not turn
off all the electrical circuits and
may cause difficulty in restarting
the engine due to a discharged bat-
tery. Ordinarily, only the ignition
switch should be used to stop the
engine.
Caution
Even if the clutch lever is pulled to
the handlebar, the starter will not
operate if the side stand is down
and a gear is engaged.
55