Advertisement
TECHNICAL DATA
Measurands
Relative Humidity
Working range
Accuracy
at 20 °C
1)
(68 °F)
Output signal (0...100 %)
Output load
Response time τ
63
Temperature
Output signal
Output load
Accuracy
at 20 °C
1)
(68 °F)
General Data
Supply voltage U
V
Current consumption
Start up time
Electrical connection
Housing material
Protection class
CE compatibility according
Working conditions
Storage conditions
1) Traceable to intern. standards, administrated by NIST, PTB, BEV... .
(2-times standard deviation). The accuracy was calculated in accordance with EA-4/02 and with regard to GUM (Guide to the Expression of Uncertainty in Measurement).
2) EE040 is not protected against surge
EMC note USA (FCC):
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is
likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.
EMC note Canada (ICES-003):
CAN ICES-3 (A) / NMB-3 (A)
INFORMATION
Langwiesen 7 • A-4209 Engerwitzdorf
Tel: +43 7235 605-0 • Fax: +43 7235 605-8
info@epluse.com • www.epluse.com
LG Linz Fn 165761 t • UID-Nr. ATU44043101
Place of Jurisdiction: A-4020 Linz • DVR0962759
0...100 % RH
± 3 % RH (30...70 % RH)
0 - 2.5 V
≥ 5 kΩ
< 45 s duct mount
< 30 s duct mount with lateral openings
0 - 2.5 V
≥ 5 kΩ
± 0.3 °C (
0.54 °F)
5 V DC ±10%
typical 2 mA without load
< 3.5 mA at 5 kΩ load
typ. 4 sec.
appropriate for Molex 6471 (4 pins) and female crimp contacts 4809 555L
PPO – GF20, UL94HB approved
connector side: IP30
front side:
EN61326-1
2)
Industrial environment
T = -40...+85 °C
RH = 0...100 % (non condensing)
T = -40...+60 °C
RH = 0...95 % (non condensing)
The accuracy statement includes the uncertainty of the factory calibration with an enhancement factor k=2
± 5 % RH (0...95 % RH)
IP50 (duct mount)
IP20 (duct mount with lateral openings)
EN61326-2-3
(-40...185 °F)
(-40...140 °F)
+43 7235 605 0 / info@epluse.com
BA_EE040_e // v1.0 // Modification rights reserved // 350199
Advertisement
