Table of Contents
Advertisement
IUH-F117-V1-*
Operation
Memory Bank MB
This parameter specifies the bank which the read/write commands SR, ER, SW
and EW access.
ParamTyp:
Default:
Value range:
If Bank 01 (UII) is defined as the access range, the Control PC protocol can only
be changed in 16-bit mode. The PC determines many factors, including the length
of the EPC/UII. In 32-bit mode, PC and checksum CRC-16 are written together as
one word The CRC-16 is write-protected
Example:
WP1UMB.00.01.03 sets the bank to User Memory
The response from the reader is a status message. During the read operation, a
status message and the corresponding data are received as the response.
7.4
Legend
<ChanNo>:
<CHCK>:
<Code>:
<Data>:
<FDaten>:
ERP:
<ETX>:
<Read-only code>: 8-byte UID/TID
<Length>:
<ParamTyp>:
<ParamLength>
<PC>
<Status>:
<SW-No>:
40
MB
MB = .03 = User Memory
.01 = UII
.02 = TID
.03 = User Memory
IDENTControl channel
1 ASCII character, 8-bit checksum with the addition of all preceding
characters, without overflow
n-byte long EPC code
<WordNum> times 4 bytes.
<PC> & <UII/EPC>
Effective Radiated Power
1 ASCII character 03
1 ASCII character
, = number of data bytes when describing the UII-
hex
Segment + 1
Range "03", "05", "07" etc (read)
"00" (write)
Parameter type, 2 ASCII characters
Parameter length, 2 binary characters, HighByte, LowByte
Protocol control word in accordance with ISO/IEC 18000-6:2010, 2
binary characters, HighByte, LowByte
Protocol control describes the length of the UII.
Example:
.00.00 = UII with the length 00
.08.00 = UII with the length 02
.10.00 = UII with the length 04
...
.30.00 = UII with the length 12
...
1 ASCII character (see chapter 7.5)
Application software number
Advertisement
Table of Contents
