Display Reliability Tests - Cessna TR182 1979 Pilot Operating Handbook

PILOT'S OPERATING HANDBOOK
SUPPLEMENT
CESSNA 400 RNAV
(TYPE RN-478A)
14. DISTANCE Minilever Switches -- SET to standby waypoint dis-
tance.
NOTE
As first waypoint is reached, it can be replaced with the
third "standby" waypoint (already set) before placing the
RNAV "DSPL" switch to 2. Then a fourth waypoint, if
necessary, can be set with the minilever selectors.
DISPLAY RELIABILITY TESTS:
NOTE
This test must be conducted following the "Waypoint
Programming" procedures with the VHF Navigation
Receiver and DME TEST / ON-OFF switches still in the ON
position.
1. VHF Navigation Receiver Frequency Selector Switches -- SET to
VOR frequency.
2. RNAV DSPL and FLY Switches -- DSPL set to 1, FLY set to 2.
a. Readout -- DISPLAYS first waypoint bearing and distance that
was selected in Waypoint Programming.
b. Fly/Display Lamp (On RNAV Control Head) -- FLASHES.
3. RNAV DSPL and FLY Switches -- DSPL set to 2, FLY set to 1.
a. Readout -- DISPLAYS second waypoint bearing and distance.
b. Fly/Display Lamp (On RNAV Control Head) -- FLASHES.
4. RNAV DSPL and FLY Switches -- BOTH SET to same number.
a. Readout -- DISPLAYS waypoint bearing and distance as
selected by DSPL switch.
b.
Fly/Display Lamp (On RNAV Control Head) -- NOT
LIGHTED.
5. DME Mode Selector Switch -- SET to RNAV.
a. Both RN and NM Annunciators on DME -- LIGHTED.
b. RN Lamp on Course Deviation Indicator -- LIGHTS.
6. VHF Navigation Receiver Frequency Selector Switches -- SET to
LOC frequency.
a. Both RN and NM Annunciators -- LIGHTED.
b. RN Lamp on Course Deviation Indicator -- LIGHTED.
c. Course Deviation Indicator OFF (or NAV)/TO-FROM Indica-
tor -- OFF (or NAV) flag in view.
7. DME Mode Selector Switch -- SET to NAV 1, NAV
2,
or HOLD.
a. NM Annunciator on DME -- LIGHTED.
b. RN Annunciator on DME -- NOT LIGHTED.
c. RN Lamp on Course Deviation Indicator -- NOT LIGHTED.
d. Course Indicator OFF(or NAV)/TO-FROM Indicator --
Shows
TO if a usable signal is received.
1 October 1978
5