Cessna TR182 1979 Pilot Operating Handbook page 229

PILOT'S OPERATING HANDBOOK
SUPPLEMENT
FOSTER AREA NAVIGATION
(TYPE 511)
10. RNAV BEARING Readout -- OBSERVE readout for magnetic
BEARING to waypoint.
11. RNAV RANGE Readout -- OBSERVE readout of first waypoint
distance.
12. TEST Pushbutton -- PRESS and observe that the desired BEAR-
ING and RANGE readouts of the waypoint thumbwheel settings
are displayed.
a. BEARING Display Readout -- DISPLAYS readout of first
waypoint bearing.
b. RANGE Display Readout -- DISPLAYS readout of first way-
point distance.
13. DG or HSI -- CONTROL AIRCRAFT as required to maintain
desired track to or from waypoint.
NOTE
Due to wind drift, it will be necessary to fly a few degrees
plus or minus the calculated BEARING readout in order to
maintain the desired BEARING readout on the computer.
14. VOR/DME Pushbutton -- PRESS at anytime to observe the radial
and DME distance from the VORTAC associated with the way-
point,
15. Upon Waypoint Passage -- CHECK or SELECT next desired
waypomt's
VORTAC
frequency on
the
selected
Nav receiver and
then PRESS next WPTPushbutton in and repeat steps 9 through 12
to proceed to next waypoint which was dialed in the right set of
thumbwheels.
NOTE
Waypoint passage will begin to be reflected on the RNAV
BEARING display about 1.5NM from the waypoint. Way-
point passage will be reflected by a rapid change of
BEARING displays. Therefore, the pilot should fly the
established inbound predetermined DG heading until
waypoint passage has occurred or until the next waypoint
is selected.
16. Left Hand RADIAL and DISTANCE Thumbwheels -- SET to next
waypoint RADIAL and DISTANCE.
NOTE
As first waypoint is reached,
it
can be replaced with the
next waypoint RADIAL and DISTANCE. Then a new
1 October 1978 7