Removing The Display-Assembly Base; Prerequisites; Procedure - Dell Inspiron 24 5000 All-in-One Service Manual

WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your
your computer. For more safety best practices, see the Regulatory Compliance home page at
regulatory_compliance.

Prerequisites

1 Remove the stand.
2 Remove the back cover.
3 Remove the system-board
4 Remove the base panel.
5 Remove the rear-I/O bracket.
6 Remove the hard drive.
7 Remove the coin-cell battery.
8 Remove the memory modules.
9 Remove the wireless card.
10 Remove the solid-state drive/Intel
11 Remove the fan.
12 Remove the heat sink.
13 Remove the speakers.
14 Remove the power-button
15 Remove the microphones.
16 Remove the side-I/O board.
17 Remove the headset port.
18 Remove the antennas.
19 Remove the camera.
20 Remove the processor.
21 Remove the system board.
22 Remove the display panel.
23 Remove the middle frame.

Procedure

After performing all the pre-requisites, you are left with the display-assembly base.

Removing the display-assembly base

computer. After working inside your computer, follow the instructions in
shield.
Optane.
board.
After working inside
www.dell.com/
Removing the display-assembly base
52
87