Removing The Display-Assembly Base; Prerequisites; Procedure - Dell Inspiron 27 7000 Service Manual

WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your
your computer. For more safety best practices, see the Regulatory Compliance home page at
regulatory_compliance.

Prerequisites

1 Remove the stand.
2 Remove the back cover.
3 Remove the hard drive.
4 Remove the system-board
5 Remove the wireless card.
6 Remove the fan.
7 Remove the heat sink.
8 Remove the camera.
9 Remove the base cover.
10 Remove the rear-I/O bracket.
11 Remove the microphones.
12 Remove the speakers.
13 Remove the power-button
14 Remove the I/O board.
15 Remove the headset port.
16 Remove the antennas.
17 Remove the system board.
18 Remove the power-adapter
19 Remove the display panel.
20 Remove the middle frame.

Procedure

After performing the pre-requisites, you are left with the display-assembly base.
92

Removing the display-assembly base

Removing the display-assembly base
computer. After working inside your computer, follow the instructions in
shield.
board.
port. (applicable on computers with FHD displays)
54
After working inside
www.dell.com/