Mounting The Turbine; Connecting The Power Cart; Hose Configurations - Titan CAPSpray 0524000 Owner's Manual

mounting the Turbine

NOTE: If you are mounting an older caPSpray turbine,
use the self-drilling screws shown on the left.
If you are mounting a newer Titan caPSpray
turbine, use the thread-forming screws shown
on the right.
1. Insert plastic latch bracket into the bottom of the turbine as
shown.
2. Using a cordless drill with a Phillips driver, insert provided
screws into the casing using a low clutch setting. DO NOT
over-torque.
NOTE: If the drill does not have a clutch, drive the
screw with the drill until the threads start to
engage, and then tighten by hand.
3. Place the turbine onto the power cart. Push the latch
bracket in to secure the turbine.

connecting the Power cart

1. Thread the end of the fluid hose onto the pressure pot
fluid outlet and tighten.
2. Thread the other end of the material hose onto the spray
gun inlet and tighten.
Pressure Pot Outlet
English
Fluid Hose
Spray Gun
Inlet
Fluid Hose

Hose Configurations

Spraying without whip hoses
Follow the configuration below if you want to spray without the
fluid and air whip accessories.
Fluid Hose
Straps
TIP: When strapping the hoses together, start at the
spray gun and work your way back.
NOTE: 30 ft fluid hose - included with Power Cart.
30 ft air hose - included with turbine.
hose straps - included with Power cart
Spraying with whip hoses
Follow the configuration below if:
1. You already have the air whip hose and you purchased a
fluid whip hose kit.
2. You have purchased both the fluid whip hose kit and the
air hose whip kit.
Air Whip
Hose
Fluid Whip
Hose
TIP: When strapping the hoses together, start at the
spray gun and work your way back.
NOTE: 30 ft fluid hose - included with Power Cart.
30 ft air hose - included with turbine.
5 ft air whip hose - included with the cS9900 and
cS9960
5 ft fluid whip hose - sold separately.
4
Air Hose
Fluid Hose Air Hose
Straps
© Titan Tool. All rights reserved.