3. Details of Advanced Settings
This chapter explains the functions of the Advanced Settings and the related image quality problems that
can be prevented/improved by adjusting these settings. For detailed procedure, see the
Troubleshooting manual.
Overview
Print Mode
Image quality is adjusted in balance with productivity according to the print mode (BW/FC/FCS/S),
which differ in the maximum toner amount, i.e. bias needed for transfer and heat needed for fusing.
It is important not to mix up the adjustments, especially the items that have similar names like 1232:
[Fusing Temperature].
The following table describes the relation between the pint mode and the image data sent from the color
controller.
Print data
K only
*1
CMYK
*2
CMYK+S
S only
*1 Job is run in FC mode, if the print data contains C, M, or Y.
*2 Job is run in FCS mode, if print data contains C, M, or Y and S.
*3 If the color controller E-45A is connected and Clear toner is installed in the special color station, check box
[High image quality] appears in the [Special Color] tab in Job Properties of Command WorkStation. If the
check is removed, priority is given to Productivity over Image Quality, as the maximum toner amount will be
limited to 260% (identical to FC mode).
Print mode
BW
FC
*3
FCS
S
Max toner amount
100%
260%
360%
100%
27