Download  Print this page

Attaching The Fan Blades; Installing The Light Kit; Installing The Glass Shade; Transmitter - GE 20314 User Manual

1.32 m (52 in.) treviso led lighted ceiling fan
Hide thumbs

Advertisement

Table of Contents
NOTE: Before starting installation, disconnect the power by turning off the circuit breaker or removing the fuse at
fuse box. Turning power off using the fan switch may not be suf cient to prevent electric shock.
ATTACHING THE FAN
BLADES
1.
P
G
F
Insert the blade (P) through the slot in the
bottom band, align the holes in the blade
(P) and the bracket, secure with the blade
screws (F) and fiber washers (G) provided.
Repeat this procedure with the other
blades (P).

INSTALLING THE GLASS SHADE

1.
T
U
Raise glass shade (U) up against the light
kit (T) and secure it to fan by twisting glass
(U) clockwise until snug. Do not over-
tighten.
WARNING: Make sure to fully secure
the glass shade in place by turning
the shade clockwise until it is locked
in place and can no longer be rotated.
10
Fan Installation

INSTALLING THE LIGHT KIT

1.
S
W
Remove the 1 of 3 mounting plate screws
(W) from the bottom of motor assembly
(R) and keep it for future use. Loosen the
other 2 screws (do not remove). Place
the key holes on the mounting plate (S)
over the 2 mounting plate screws (W)
previously loosened, turn the mounting
plate (S) until it locks in place at the
narrow section of the key holes. Secure
by tightening the 2 screws previously
loosened and the one previously removed.
INSTALLING THE TRANSMITTER HOLDER
1.
Select a location to install your transmitter
holder (L). Attach the transmitter holder (L) with
the two short wood screws (N) provided.
2.
S
Remove the 1 of 3 light kit mounting
screws (X) from the mounting plate (S)
and keep it for future use. Loosen the
other 2 screws (do not remove). While
holding the LED light kit (T) under the fan
motor assembly, make the 2-pin wire
connections: Blue to blue and white to
white. Place the key holes on the LED light
kit (T) over the 2 light kit mounting screws
(X) previously loosened, turn the LED light
kit (T) until it locks in place at the narrow
section of key holes. Secure by tightening
the 2 screws previously loosened and the
one previously removed.
L
N
T
X

Advertisement

Table of Contents
loading

  Also See for GE 20314

  Related Manuals for GE 20314

This manual is also suitable for:

20321