Omron V720S-BC5D4A User Manual page 118

5-7
Setting Command
<Response Format>
STX Node No. Retry
1 2
Response code:
Port No.
Baud rate
Data length
Parity bit
Stop bit
BCC
Enabled/Disabled
ACK/NACK
Timeout
：・The setting is enabled after reset by the Reset Command(XZ). To enable the setting forthe
next start-up, the setting must be saved by Set Value Writing (EW).
Command Response
flag code code:
"CP" "00"
1 2 2
00: Normal completion
For other Response Codes, refer to Response Code List.
Indicates the number corresponding to the specified terminal resistance.
Indicates the number corresponding to the specified baud rate.
Indicates the number corresponding to the specified data length.
Indicates the number corresponding to the specified parity bit.
Indicates the number corresponding to the specified stop bit.
Indicates the number corresponding to the specified BCC setting.
Indicates the number corresponding to the specified control mode.
Indicates the number corresponding to the specified timeout period.
Port Baud Data Parity
No. rate length bit
1 1 1 1
Stop BCC ACK Time
bit Enabled NACK out
/Disabled
1 1 1
5-7
ETX BCC
1 1 1
5-57