Esc T N; Esc W Xl Xh Yl Yh Dxl Dxh Dyl Dyh - Bematech LR2000 Programming Manual

 Data buffered in page mode is cleared.
 This command sets the print position to the beginning of the line.
 The printing area set by ESC W is initialized.
 This command switches the settings for the following commands (in which the
[Reference] FF, ESC FF, ESC L

ESC T n

[Name] Select print direction in page mode
[Format] ASCII
Hex
Decimal
0 n 3
[Range]
48 n 51
[Description] Selects the print direction and starting position in page mode.
n specifies the print direction and starting position as follows:
 When the command is input in standard mode, the printer executes only internal
[Notes]
 This command sets the position where data is buffered within the printing areaset
[Default] n = 0
[Reference] ESC $, ESC L, ESC W, ESC \, GS $, GS \

ESC W xL xH yL yH dxL dxH dyL dyH

[Name] Set printing area in page mode
values can be set independently in standard mode and page mode) to those for
standard mode:

Set right-side character spacing: ESC SP

Select default line spacing: ESC 2, ESC 3
ESC T n
1B 54 n
27 84 n
n Print Direction
0,48 Left to right
1,49 Bottom to top
2,50 Right to left
3,51 Top to bottom
flag operation. This command does not affect printing in standard mode.
by ESC W.
Starting Position
Upper left
(A in the figure)
Lower left
(B in the figure)
Lower right
(C in the figure)
Upper right
(D in the figure)
LR2000 Programming Manual V1.2