Gs $ Nl Nh - Bematech LR2000 Programming Manual

GS $ nL nH

[Name] Set absolute vertical print position in page mode
[Format] ASCII
Hex
Decimal
0 nL 255, 0 nH 255
[Range]
 Sets the absolute vertical print starting position to buffer character data in
[Description]
 This command sets the absolute print position to [(nL + nH 256) ×0.141 mm].
 This command is effective only in page mode.
[Notes]
 If the [(nL + nH×256) × (vertical or horizontal motion units)] exceeds the specified
 The horizontal starting buffer position does not move.
 The reference starting position is that specified by ESC T.
 This command operates as follows, depending on the starting position of the
[Reference] ESC $, ESC T, ESC W, ESC \, GS \
GS \ nL nH
[Name] Set relative vertical print position in page mode
[Format] ASCII
Hex
Decimal
0 nL 255
[Range]
0 nH 255
[Description] Sets the relative vertical print starting position from the current position in page mode.
 This command sets the distance from the current position to [(nL + nH ×256)×
 This command is ignored unless page mode is selected.
[Notes]
 When pitch N is specified for the movement downward:
GS $ nL nH
1D 24 nL nH
29 36 nL nH
pagemode.
printing area, this command is ignored.
printing area specified by ESC T:
When the starting position is set to the upper left or lower right, this command sets
the absolute position in the vertical direction.
When the starting position is set to the upper right or lower left, this command sets
the absolute position in the horizontal direction.
GS \ nL nH
1D 5C nL nH
29 92 nL nH
0.141 mm (0.0055")].
nL + nH ×256 = N
When pitch N is specified for the movement upward (the negative direction),use the
complement of 65536.
When pitch N is specified for the movement upward:
LR2000 Programming Manual V1.2