The pulse ON time is [t x 100 ms] and the OFF time is [ t x 100 ms].
When the pulse is output to the connector pin specified while ESC p or DEL DC4 is
[Details]
With a serial interface model, this command is executed even when the printer is
With a parallel interface model, this command is not executed even when the printer
If printer data includes the same character strings as this command, the printer
This command should not be used within the data sequence of another command
This command is effective even when the printer is disabled with ESC = (Select
[Reference]
ESC p
ESC SP n
[Name]
Set right-side character spacing
[Format]
ASCII
Hex
Decimal
[Range]
[Description]
Sets the character spacing for the right side of the character to [n×0.141 mm (n×
0.0055")].
The right-side character spacing for double-width mode is twice the normal value.
[Notes]
This command does not affect the setting of Kanji characters.
This command sets values independently in standard mode.
[Default]
n = 0
ESC ! n
[Name]
Select print mode(s)
[Format]
ASCII
Hex
Decimal
0 n 255
[Range]
[Description]
Selects print mode(s) using n as follows:
Bit
0
executed while this command is processed,this command is ignored.
receive the command.
is receive the command.
performs the same operation specified by this command. The user must consider
this.
that consists of 2 or more bytes.
peripheral device).
ESC
SP n
1B
20 n
27
32 n
0 n 255
When characters are enlarged, the right-side character spacing is n times normal
value.
ESC !
n
1B
21 n
27
33 n
Off/On
Hex
Decimal
Off
00
0
On
01
1
LR2000 Programming Manual V1.2
Function
Character Font A (12×24).
Character Font B (9×17).