Fs W N - Bematech LR2000 Programming Manual

0 n1 255
[Range]
0 n2 255
[Description] Sets left- and right-side Kanji character spacing to n1 and n2, respectively.
 The left-side character spacing is [n1×0.141 mm], and the right-side character
 This command sets the left- and right-side character spacing for normal-sized
[Notes]
 The spacing which is set with this command can be set independently in standard
 In standard mode, the horizontal motion unit is used.
[Default] n1 = 0, n2 = 0

FS W n

[Name] Turn quadruple-size mode on/off for Kanji characters
[Format] ASCII
Hex
Decimal
0 n255
[Range]
[Description] Turns quadruple-size mode on or off for Kanji characters.
 When the LSB of n is 0, quadruple-size mode for Kanji characters is turned off.
 When the LSB of n is 1, quadruple-size mode for Kanji characters is turned on.
 Only the lowest bit of n is valid.
[Notes]
 In quadruple-size mode, the printer prints the same size characters as when
 When quadruple-size mode is turned off using this command, the following
 When some of the characters on a line are different in height, all the characters on
 When characters are enlarged in the horizontal direction, they are enlarged to the
 FS ! or GS ! can also select and cancel quadruple-size mode by selecting double-
[Default] n = 0
[Reference] FS !, GS !
spacing is [n2×0.141 mm].
characters. When double-width mode is set, the left- and right-side character
spacing is twice the normal value.
mode.
FS W n
1C 57 n
28 87 n
double-width and double-height modes are both turned on.
characters are printed in normal size.
the line are aligned at the baseline.
right, based on the left side of the character.
height and double-width modes, and the setting of the last received command is
effective.
LR2000 Programming Manual V1.2