Interface Modules - H3C SecPath F1000-E Installation Manual

Installation Manual
H3C SecPath F1000-E Firewall
Note:
You can refer to the table above when distinguishing between or preparing these
two types of Ethernet cables.
When preparing Ethernet cables, please follow the chromatogram given in the table
to arrange the wires. Otherwise communication quality will be affected even if the
devices at both ends are connected.
When preparing Ethernet cables, use shielded cables preferentially for
electromagnetic compatibility (EMC).
6) Cable connecting a 1000 Mbps optical Ethernet interface
You can use a single-mode or multimode optical fiber to connect a 1000 Mbps optical
Ethernet interface to an Ethernet. You can select proper fibers for the installed
1000Base-FX SFP modules. Since the optical interfaces on these SFP modules use
LC optical connectors, you must use fibers with LC connectors. All SFP modules are
hot-swappable.
Note:
No SFP module is shipped with the F1000-E.
Use only the SFP modules provided by H3C. The F1000-E cannot identify SFP
modules from other manufacturers.
For the connection of electrical Ethernet interfaces or optical Ethernet interfaces,
refer to section 4.10.3 "Connecting Ethernet Cables" in Chapter 4 "Installing the
Firewall".

1.4.4 Interface Modules

The F1000-E provides two HIM slots.
Table 1-18 HIMs supported by the F1000-E
Module name
8GBE
4GBE
8-port 1000 Mbps electrical Ethernet interface module (WAN)
4-port 1000 Mbps electrical Ethernet interface module (WAN)
1-19
Chapter 1 Product Overview
Description