Weighing; User Functions; Parts Counting Function - Adam Equipment LBX 12 User Manual

5.2

WEIGHING

•
Press [On/Off] to turn on the scale. The display will show the software
revision then show the model "CAP XX". Then it will begin its self-checking
test from 0 to 9. When reading is stable, the display will show " . ", stable
symbol, zero symbol, and the weighing unit used the last time the scale was
used.
•
Press [UNITS/ → ] to select units from "g" / "kg" / "lb" / "oz"/"lb:oz". Only the
weighing units enabled will be displayed, See section 6.8.
•
Check if the reading is " . ", if not, press [Zero]. " . " and the zero symbol
will be displayed.
•
Put the item to be weighed on the pan. When the reading is stable, the gross
weight will be shown.
If a container is used, put the container on the pan and press the [Tare/↵] key when the
reading is stable. The display will show " . ", the zero symbol and 'NET'. Load the
container or remove material from the container, the scale will show the net weight of the
material added or removed.
5.3

USER FUNCTIONS

The parts counting, percent weighing and calibration functions can be accessed using the
[FUNC/↑] key, if the functions have been enabled as described in section 6.0.
If the function is turned off the function will not be available. Only functions that have been
turned on can be accessed.

5.3.1 PARTS COUNTING FUNCTION

•
In normal weighing mode, press [FUNC/ ↑ ] until the display shows "SAP 10".
•
Press the [UNITS/ → ] key to go through the preset sample piece values of
10, 20, 50, 100 or 200 pieces. For example, if you selected SAP-20pcs, hand
count out 20 pieces and put them on the scale.
© Adam Equipment Company 2018
5