Wire And Gas Combinations; Different Pulsing Methods; Wire Feed Unit - ESAB Aristo U82 Instruction Manual

4 MIG/MAG WELDING
4.3.1

Wire and gas combinations

For wire and gas combinations, see the "WIRE AND GAS DIMENSIONS" appendix at the
end of this manual.
4.3.2

Different pulsing methods

Below you can see which pulsing method can be used, depending on the plate thickness that
is to be welded.
Heat
A = Pulsing in primary phase and short arc in secondary phase
B = Pulsing in primary phase and pulsing in secondary phase
C = Spray in primary phase and pulsing in secondary phase
4.3.3

Wire feed unit

Only use wire feed unit Feed 3004 during SuperPulse welding.
Precautionary measures!
When using SuperPulse, there is a considerable load on the wire feed unit. In order of the
functional safety of the wire feed unit not to be endangered, follow the limit values in the
following diagram.
0460 896 274 - 29 -
Plate dimension
© ESAB AB 2013