Set The Termination Switch On Digisuite Lx; Connect The Vip Cable To Your Max Card - Matrox DigiSuite LX MAX User & Installation Manual

24

Set the termination switch on DigiSuite LX

Connect the VIP cable to your MAX card

Chapter 4, Installing Your DigiSuite LX MAX Hardware
DigiSuite LX provides a DIP switch for 75-ohm blackburst termination for
the REF IN connection. This is located at the top of the module board near
the connection end of the card.
Switches 1 and 2 in "ON" position for
Switch position
for Hi Z
(required for use with
DigiConnect/Video)
Normally, you should set both switches to the position marked "ON"
before installing DigiSuite LX in your system. If you're using the
DigiConnect/Video breakout box or another device for termination,
however, set both termination switches to Hi Z.
If your VIP cable was not shipped already attached to your Matrox MAX
card, you must attach one end of the VIP cable to the connector on the
component side of your MAX card before you assemble your card set.
Make sure that the red edge of the cable is connected towards the top of the
card (closest to the Movie-2 bus connector).
75 Ω termination